樹莓派3也直接支援藍芽，使用直接使用自帶命令即可,先開啟要連線的藍芽裝置,然後配置樹莓派:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
pi@raspi3:~ $sudobluetoothctl
[new] controller bb:27:eb:0d:9d:dd raspi3 [default]
[bluetooth]# list
controller bb:27:eb:0d:9d:dd raspi3 [default]
[bluetooth]# power on
changing power on succeeded
[bluetooth]# scan on
discovery started
[chg] controller bb:27:eb:0d:9d:dd discovering:yes
[new] device e8:07:bf:3a:25:aa ndz-03-ga
[chg] device e8:07:bf:3a:25:aa rssi: -66
[bluetooth]# agent on
agent registered
[chg] device e8:07:bf:3a:25:aa rssi: -56
[bluetooth]# pair e8:07:bf:3a:25:aa
attempting to pair with e8:07:bf:3a:25:aa
[chg] device e8:07:bf:3a:25:aa connected:yes
[chg] device e8:07:bf:3a:25:aa uuids:
00001108-0000-1000-8000-00805f9b34ff
[chg] device e8:07:bf:3a:25:aa paired:yes
pairing successful
[chg] device e8:07:bf:3a:25:aa connected: no
[bluetooth]# trust e8:07:bf:3a:25:aa
[chg] device e8:07:bf:3a:25:aa trusted:yes
changing e8:07:bf:3a:25:aa trust succeeded
[bluetooth]# connect e8:07:bf:3a:25:aa
這樣就連上藍芽裝置了，如果是藍芽音響的話還得裝下支援軟體:
1
sudoapt-getinstallpulseaudio pulseaudio-module-bluetooth
樹莓派 連線藍芽耳機
開發板 樹莓派3b 系統 raspbian 樹莓派外接顯示屏後，預設是通過hdmi音訊輸出。我的顯示器是vga介面，通過hdmi轉vga輸出到電腦上，所以沒有聲音。於是採用藍芽耳機進行音訊輸出 一開始，搜尋到我的藍芽耳機，配對成功後馬上斷開，再次連線，提示 connection failed use...
樹莓派如何配置wifi連線
在sd卡根目錄放置乙個檔名為wpa supplicant.conf的檔案，內容如下 country gb ctrl inte ce dir var run wpa supplicant group netdev update config 1 network 新版的樹莓派系統，為了自帶wifi的樹莓...
樹莓派3代上手 初始化配置
其實我也是按照官網的教程一步步來，呵呵。結果我還是沒有用md格式來寫，哎我好懶 installing software in raspbian 這次就按照這裡來 updating upgrading raspbian configuring raspbian raspi config config....